With apologies to Ben Franklin.
My last beer fermented a little too warm and turned out full of esters. What I am calling The Fruity Brit is still drinkable as demonstrated last night when Adie and I had eight friends over for pizza and beer. The first keg is at least three gallons light. A good time was had by all, even without chairs.
The Fruity Brit is light on hops and body. I can pretend there is a clean malt profile, but the fermentation flaws overpower that. However, I hit the alcohol content right on the button: non-offensive. The Brit’s gravity bottomed out at 4° brix falling from 6°, putting it at about 2.3% ABV. Next time I will start and end higher, and throw in more hops for good measure. My objective is to zero in on a medium-bodied, lightly hopped British session beer.
While gatherings of friends will continue, I do not anticipate unaided fermentations to turn out any better. As summer approaches, Texas ain’t getting cooler. In Redwood City I had a chest freezer with good control over bubbling carboys, but now I have fifteen gallon conicals towering four feet tall on PVC stands. Such things just do not fit in this sort of chest freezer. A proper stand-up freezer runs around $500 and Craig’s List here is pretty pathetic. Those stand-up freezers only fit one of my fermenters, but I expect to be brewing with increasing frequency.
Three weeks ago I started working on a walk-in cooler that could accommodate both my fifteen gallon conicals. Many entwined brewers might meet steep resistance from their significant others, but my beautiful wife simply smiled and told me what a great idea it was. My initial estimate for materials was two hundred dollars easy, but I will probably go over by around fifty percent. While I may get a grimace from Sweetie, I know she will support me. It makes me all warm and fuzzy thinking of how much she must love me.
To drive the cooler I have a window air conditioner (which I wanted to leave in Cali, but Adrienne insisted we keep it; how smart). Here is how my cooler starts; left to right, the frame for the bottom and top.
Then a semi-rigid plastic interior layer glued and stapled to the frame (see below). The floor gets a layer of plywood under the plastic to support the weight of the fermenting beer. Here is a shot of the bottom corner, the frame nailed to the floor.
Here is the back. The large opening is the AC mount. Clay is putting the light switch in center-top in our make-shift wiring box. All of the standard-type electrical bits and bobs are made for 2×4 studs while my walls are one and three-quarters thick, so we have to be creative.
Here is Clay again working on the light fixture. It is slightly too deep for the ceiling so we shimmed it out, taking advantage of the flexible plastic to hide the protrusion. We filled this with insulation and covered in plywood.
In parting, I would like to thank Adrienne for allowing this project to take up my time, our money and her “pretty living room” for three weeks, going on six. I love you sweetie.